Building Custom Mag - Need Help!

[LaPs]

I'm trying my hand at building a mag and I'm definitely finding out how little I really know about this marker. So far I have the following:

1. ULE Body
2. Classic Rail
3. Intelliframe
4. Vertical Adaptor

Now that I finally got the twistlock out of the rail, I need to get the body, frame, rail, and VA attached. A couple of things confuse me though:

1. Do the frame, rail, and ULE all attach together with one screw? Can I get this screw at airgun.com?
2. Where is the hole to mount the VA? There is a well on the top of the rail, do I need to drill this out to mount the VA?

Other than what I already have, what else do I need besides a valve, ASA, macroline? Do I need a nubbin? What hardware is needed to install the valve? Gonna need a sear for the intelliframe right?

I think that's about all for now. Sorry for the bombardment of questions, I appreciate any help you guys can give me. Thanks!

[MrTQ2001]

u put this all together with a screw through the middle of the frame. and it all locks together. then the field strip screw holds the valve in. mags are very simple guns, just need to learn the tricks.

[LaPs]

Alright well that takes care of how the frame is mounted? But what about the vertical adaptor? There's no hole...do I have the wrong rail?

[Blurry]

vertical

knock that hole all the way through the rail where u seen the well. Now you will need a fieldstrip screw, sear roll pin and sear, that should get the bulk of your gun together pm me with any other questions