I think Im screwed

[Geoff Noble]

As i was taking apart my vlave i noticed a teflon o ring in the on off valve was worn out. I replaced in, but i guess i put it in worng. As i went to put it in i pushed the on/off in too far, and now i can't get it out. Any suggestions??

[Geoff Noble]

more to come

[Geoff Noble]

another

[Geoff Noble]

last one

[PyRo]

How is it in too far? You forgot to put the top in or something?
Well, if you screw on the reg, and put a little gas in it, it will shoot out.
Or what I do is to stick something thin down the power tube and use that to work the on/off up. You could break something like this though.

[Muzikman]

Well, the eay way to get it out is to cup it in your hand and give it a REALLY quick gas up. This will shoot the on/off bottom out. The other way is to use a paper clip or dental pic and try to pull it out by the center hole.

BTW, chances are you forgot to put the on/off top (brass piece) in before you put the on/off bottom in. Don't sweat it, it's happened to everyone atleast once

[Geoff Noble]

Thanks guys, i just fixed it by gasing up the gun, and the thing came flyin out. Thanks a lot for your help, i apperciate it a lot.

[Phatty]

The safest way is put the whole thing together then gas it up, it will only shoot out as far as the body rail. Not much chance of you injuring yourself.

[PyRo]

True true, but too late now
As long as you don't hit yourself in the eye your fine.

[TheBigRaguPB4L]

Originally posted by Muzikman


BTW, chances are you forgot to put the on/off top (brass piece) in before you put the on/off bottom in. Don't sweat it, it's happened to everyone atleast once

it never happened to me, knock on wood.

[DYE-BaLLeR]

happened to me and the easiest way to get it out is put a cloth over a wood table and over the valve and hit the valve on the table, it will come out after like 4 hits

[X-Plosive]

It's too late but I just take the proper size allen key and gently push it in. I then spiral it back out and the on off assembly comes right out. By the way to do this you obviously need the on/off pin out. It doesn't damage the on/off either. As for the gassing up thing, it's not to safe. Specially if you left the pin in.

[Thordic]

I left the on/off top out once.. I sat there slamming the valve into a table for a while.

Thank god for sturdy AGD steel!

haha

[PyRo]

I have left mine out purposly because i got bored

[Magsrule3]

Hey Geoff I noticed your from Duxbury, where do you play? Me and my team play at Global usually and we just did a tooourney at Heaven. You should go to Global sometime and play.