MicroMag and INTELLIFRAME

[n8-J]

Would the intelliframe fit my micromag??? I am in the market for a nice double finger trigger. I have a ricochet hopper so the electronics are a necessity (sp) What would you guys suggest for a trigger frame?
Thanks


n8j

[smilestyler]

Some older micromags need the lip on the proteam grip frame to hold the sear pin in. If yours is an older one the intelliframe won't hold it in and you will need to figure out another way to keep it in. Newer micros are no problem. Whatever the case, inteliframes are the best choice imo.

[n8-J]

Yeppers

Yeah I have an older Micro and it does require the lip to hold the sear pin. Any other trigger frame match the intelliframe.

Thanks

[smilestyler]

I just put a drop of silicone over the hole to seal the pin in there. I rarely take the sear out, and just put a new dab of silicone each time I do. I'm sure there are better ways to deal with this. Like a set screw from the bottom

[goldengun5]

hey is 90 for a blade itelliframe a good deal

[n8-J]

I was wondering if I could just replace the body frame with a newer one. I know on Proteam Products the sells the Micro mag 2000 update. Anyone know if you can just buy the body frame, and how much???

Thanks