halo B loader problems

[tapdata55]

hey wassup,

I have some problems with my halo b loader. First of all, the circuit board fried last week when paint broke inside. The paint dripped into the circuit board and caused it to fry. So after that I decided to by a new board with the z-code. I installed it today but still having problems. When I turn on the halo, the green light starts blinking and then the loader will spin 3 times. After the third time the loader starts blinking green to red. This is suppose to happen when theres a jam, or when the batteries are low. So I tried new batteries, even tried putting paint in the loader. As of now its doing the same thing. Can anyone help? Thanks

James

[xen_100]

with no paint in the hopper, I beleive that is what Z-code is supposed to do. it doesn't just sit there and spin-stop-spin until the batts are dead. (it spins three times, saw no paint go by, so it assumes there is a jam.. or in this case, no paint in the hopper)

put some paint in it and see what it does.