minimag with hyperframe upgrade

[tg ur 1t]

I have a minimag (Classic valve) with hyperframe and warp for a back-up marker. I want to go lvl 10 but I am unsure if I should/ can upgrade from the classic valve or not. I don't know if the reactive side of the newer valve/ trigger will allow it to work with the hyperframe.
I am also wondering if the recharge rate of the X-valve is significantly better than the classic, enough so to need to upgrade beyond the classic valve... and again, this is even if I can even do this with the Hyperframe.
So...

1. Will the X-valve lvl 10 fit and work on my minimag?
2. Is it worth it to go X-valve or just go lvl 10?

Thank you.

[Dayspring]

1) Xvalve will work just fine.
2) Up to you. The new Hyperframe boards are capped at 20bps. Classic valves top out around 16. If you want MAXIMUM performance, you want the Xvalve. (And add the ULT in the mix. Makes it easier for the 'noid to fire the gun.)
3) Yes. The Xvalve recharge rate is head ans SHOULDERS above the classic valve.

[tg ur 1t]

thanks Dayspring. I appreciate it.
Quick question about the ULT though. I thought you didn't put the ULT on electric because the pull on the trigger is like clicking a mouse. Am I mistaken?

[Dayspring]

One of the main problems the Hyperframe had was using it's small solenoid to push the on/off pin of the mag. Using the ULT, the force to push the pin is reduced SIGNIFICANTLY.

It's a good thing.