troubleshooting question

[jenkie]

Just bought a used mag rt pro off ebay. I got a good deal on it and it worked fine before I took it apart to replace the O rings. I watched the video the seller included with it and my rt's body doesnt look anything like the one in the video.

The RT also has a level 10 bolt. I replaced the o-rings and the power tube spring and now I am getting a constant leak from the barrel, unlike what they talk about in the video. Also, if I tighten the regulator too far, I get a machine gun type effect. Does anyone have any ideas? It would be much appreciated

Thanks in advance,

John

[BlackVCG]

The video is outdated. It will give you some general pointers on how to work on the gun, but a lot of things have changed. Level 10 wasn't around back then and the body was different along with a few other things.

By power tube spring, do you mean the spring that goes around the bolt? There shouldn't have been a spring in the powertube. Make sure your Level 10 o-ring fit on the bolt stem is good. Slide the bolt back and forth with the valve out of the gun and see if you can feel some o-ring friction. If you can't, you need to use the same o-ring in a smaller carrier.

Also, with it leaking, push in on the bolt and see if that gets it to change pitch. If it does, it is for sure an LX carrier o-ring problem. If not, then you probably have a bad black o-ring that goes around the outside of the carrier.

[jenkie]

thanks for the reply... yes it is the spring around my bolt. Got my terms confused. What is the LX carrier? Is there any doc that diagrams where it's o-ring is

thanks again,

John

[BlackVCG]

At the top of this forum go to the Resource section and go to the Level 10 guide.