leak in my mag

[Q01]

i have a leak in my mag valve. i cant pinpoint it. there is a very faint and contand leak comingg from about the area where you srew the 2 halfs of the valve together. i checked the oring. i cleanded my on/off and nothing. i turned velocity down and nithing. what could it be. i am sure the air is not leaking from the place where velocity is adjusted. could it be a bad seal at the part with the smal pin valve thingy.

Added, reg seat is realy loose no mater which way it is put in

[PyRo]

I would say get a new reg seat even if that isn't the problem. Maybie the leak is from the connection between the hose and the valve?

[Q01]

no not from hose to valve because i feel air coming from up from under the main rail so it must be on off or the reg

[PyRo]

Thats the on-off check your o-rings replace them if you have spares. Inspect them carfully small nicks can cause leaks.

[Q01]

but it seems to be coming from the area where the reg screws into the rest of the valve. could my reg be over oiled and leaking outta the 2 holes on the bottem next to the slide lock thing

[PyRo]

Those 2 holes shouldn't leak unless you put some massive amount of pressure into your valve where it starts venting to avoid blowing up.

[Q01]

the leak is from where the reg screw in i gassed it up and it frosted all around the place where the screw together
what could it be?

[PyRo]

Mags like N2, you can pick up a tank fairly cheap.
Have you checked that big o-ring? Try the reg seat too.

[Q01]

there was alot of oil behind the bog o-ring and it fire fine no leak, but i will keep my eye on it, my n2 is getting fixed(got it from crossfire and it leaked when i got it)

[athomas]

Over oiling can cause leaks. An excessive amount of oil on an o-ring prevents it from sealing. This holds true for all o-rings.

[Q01]

the leak is back, i will just buy a new reg seat, reg o-ring and maby some on off valve orings to be safe