on/off valve

[jdaniels]

how is the on off valve taken out. i have pulled on it but no luck and i dont want to break it. bought the gun used and i need to replace some o rings.

[Dayspring]

Just give it a pull.

if need be, use something with an edge (dental pick of knife) and pry it out gently.

Trust me. You won't hurt anything.

[PyRo]

Don't go to crazy, someone on here did manage to mess it up pulling it out with a big wrench a while ago.

[Echo419]

Hey

I had the same thing when i got my gun, heres hwta u do.

Pull out the pin that goes all the way through the on off valve.

Get some tweezers with a bent edge.

Shove them down the whole and rotate it so it cant slip out

Pull hard, and itll come right out

[SkyBoySurfer]

back presure inside the valve ...always shoots mine out almost every time i pull out my piston....

thats probibly becuse i never take off my tank...i use the on off on the cradle...so i never let the gas vent.

[PyRo]

You could just gas up the gun, that will shoot it right out. Just make sure you shoot it somewhere that you will be able to find the parts since it will come out very fast, and use as little air as possible to do it.

[jdaniels]

shot right out

that thing shot right out. Now i have to download the book for it and figure out how to put it back in. thanks guys.

[SkyBoySurfer]

The on/off instruction are placed on the bottom of the valve (on the valve it self)

just look at the diagram...and follow it from front to back.

[PyRo]

First thing in is a big o-ring with a small white one inside it. Then the on-off top goes in (smaller piece with the holes in the sides). Then the on-off top should have 1 white o-ring in the top of it, and one larger o-ring around the side, this goes in next white o-ring up. Then just put the pin in (little ball like thing facing down).