Constant Barrel Leak

[greenkill]

I decided to fine tune my level 10 this weekend. I followed the level 10 installation video, with the 2 Line spacer and 2 shims with the largest spring. This seemed to work very well as it wouldn't fire if anything obstructed the path of the bolt. However, I am getting a constant leak from the bolt. I tried removing 1 shim at a time, and it still leaked. After reading the installation of the Level 10, it said to wiggle the bolt to check to see if there leak hissing changed its sound. It did, the solution was to go to a smaller spacer. So I tried the 1 line spacer. With this set up the marker would not fire at all. I figured that I should try turning up the regulator, but that only created a leak from the back of the xvalve. So I downed the pressure.

Any suggestions on what I should do.

My setup
ULE Body
Intelliframe
Xvalve

Thanks.

[ChucktheMAGician]

Try the 1.5 spacer. Starting w/ the 2 and switching to 1 you moved down 2 sizes. 1.5 = one line and dots

[greenkill]

thanks that worked wonders.

I was wondering what those dots meant.