Trigger sencibility

[C_22]

This is the tech forum so I hope the question belongs here

After one month of playing with the XMag I've gotten used to it pretty well. The only thing I want to do is make my mag's trigger pull shorter and/or easier. How do I work with the magnets to acomplish this? What are the "DO's" and "DO NOT's" or your recomendations when looking into that area?

Thanks...

[Dayspring]

There is really only 2 don'ts

1- don't make it so tight that the gun won't turn on. (Trigger magnet is too close to sensor and the board won't boot up right. Check this by turning on/off the gun. If it flashes weird characters, back the magnet in the trigger out.)

2- do NOT mess with the trigger rod.

Anything else is fair game.

You can put spacers in the gripframe under the top magnet to give you a little looser pull

You can mess with the set-screw on the mode selector switch. (Will limit backward travel on E pull)

You can mess with the trigger magnet. (Determines where in the stroke the gun will fire.)

[C_22]

Thanks a lot!

[ChucktheMAGician]

This should be a good reference too. http://www.automags.org/forums/showt...threadid=83104

[C_22]

Wow... very ilustrative

Thanks guys, a lot.