The back half of my retro valve comes lose after around 50-100 shots. Is there a proper way to prevent this from happening? Anyone else got this problem? Im alittle hesitant to put some weak lock tite on the threads.
-
Kila V2 Magnetic Suspension Detents for Angel 04 Speed, LED, LCD, IR3's, X-mag, ULE Mag, TAC-1, SFL Emag, NYX Matrix, E-blade, Mac Dev Cyborg, Bushmaster 2000, All other Cocker threaded guns, Shocker, Nerve, Impulse
Kila V2 for Alias...the ountdown is on!
Email: [email protected]
www.kilaproducts.com
AO PM: kilaueakid -
dont worry about it too much.... most of the valves i have seen do this and there should be a little post on the back half of yours that slides into the bodyrail... that little post will keep it from undoing itselfVirus, King of the Basement Trollz has spoken
-
When the back half becomes loose does the gun still shoot but the balls just plop about 5 metres in front of u.
I had this with my E-mag, when I inspected the valve it was about 4 mm off the mark, I just want to make sure that I managed to find my problem, sorry I cant really help you but dont locktight the thing.Comment
-
virus...
I don't have a post on mine...it is a sfl emag.
goblin...it hasn't been an issue yet with the balls just plopping out, I usually notice it and hand tighten it every so often, but would be nice to correct the problem.
kilaKila V2 Magnetic Suspension Detents for Angel 04 Speed, LED, LCD, IR3's, X-mag, ULE Mag, TAC-1, SFL Emag, NYX Matrix, E-blade, Mac Dev Cyborg, Bushmaster 2000, All other Cocker threaded guns, Shocker, Nerve, Impulse
Kila V2 for Alias...the ountdown is on!
Email: [email protected]
www.kilaproducts.com
AO PM: kilaueakidComment
-
Hey kilaueakid,
Are you sure you have this black screw on your SFL that holds the reg. body? If not, that's your problem and you need to get that screw to keep it from unscrewing.Comment
Comment