leak please help

[Nimec]

i have a leak coming out the back of my gun when ever i put my nitrogen in. it dosnt do it for co2 though. i tried turning down the velocity and it stoped but it only shoots 20 feet

[PyRo]

Try turning down your velocity?

[Russ]

Welcome to AO

Follow the link on the top of each page to Airgun designs. There you will be able to find downloadable versions of all their manuals. If you call (or e-mail) AGD to register your gun, and if you ask politely, they will send you a maintenence video, free of charge (maybe some stickers, too!)

I strongly recommend you take some time and surf through AGD's website. There's a lot of troubleshooting info there.

I'll bet you'll be able to figure out what's wrong with your gun. Good Luck

[Nimec]

done

thanks for the advice. i took it apart and now it seems to be working.

[EnW]

You took it apart and now it works??
hehe!!!!

[Nimec]

scratch that

it's not working like i seemed it was. turning down the velocity does stop the leak but it only shoots the ball 15 feet. this is starting to piss me off. i need some help.

[PyRo]

If you have a new reg seat, replace it. If not make sure the one you have is in the right way, it should snap into the back half of the valve. One end is bigger that the other, bigger end will snap in, smaller end won't.

[Nimec]

yeah i have the seat in right but it still wont work

[Nimec]

ahhhaaa

could it posibly be a bent on/off pin?

[BlackVCG]

Try replacing the piston o-ring with a new one and oiling it. Crank it up to where it's shooting at about 300fps and it should NOT leak out the back. If it still does, you have a defective piston and need to call AGD for a new one.

[Nimec]

ok. thanks.