3.2 questions

[whopper72]

Just got my x-mag back, updated with 3.2 program. I have a few questions though.

1. On the ace settings are the 0, 1, 2, the same as they were on 2.4? (0=off, 1=short delay 2=long delay)
2. there is an added setting on it. (SHBF) what is this and what does it do, and what should it be set at. (set at 54 from agd)

[TheDuelist]

I don't have an ACE on my EMag so I can't help you there but as far as the 3.2 shot buffering goes, read this thread.

http://www.automags.org/forums/showthread.php?s=&threadid=110747

[rikkter]

in ACE, 0 is off
but on these, i'm not too ture
i THINK
1 is one color shell paint
2 is two color shell paint

[Miscue]

Yeah, 1-2 = delays. Longer delay for 2-tone paint.

SHBF = x milliseconds that the trigger is ignored after firing. (Debounce)

[cledford]

What is the typical SHBF setting? Hoover just flashed my Emag and it was automatically set at 4. I noticed (the hard way) it goes to to 100. Does anyone need that much adjustment?

Also, not that I'd use it for the forces of evil, but does it act like the WAS debounce - where setting to one is basically run-away mode?

Sorry, I don't have any air to test it with.

-Calvin

[Miscue]

I've set mine to 1ms w/o bounce, and I suspect 0 or close to it would work out with a HES versus a microswitch with contact bounce. However, some boards are "noisy" and are having issues with bounce/FA.

I have my Q1.0 set up to do 1-20ms... because I personally see no reason to go beyond that and I don't want it to take forever to cycle through settings. On my gun, 1 and 20 = exact same thing. And thus far, nobody seems to be having any issues with this... except with defective boards.