ND Blade Trigger Question

[pbcustom98]

I installed the ND blade trigger, and after awhile of tinkering i figured out the trigger was already hitting the microswitch to engage and not allowing me to shoot, since it was already depressed. so i adjusted the top screw so it wasnt constantly hitting the switch. Now the problem i have is that when i shoot the trigger kinda gets stuck back..is that because i have to adjust the trigger stop? i dont have the right sized allen key for that ..yet...but ill get one..is it just the trigger stop that has to be longer? or is it something else?

Thanks
Daniel

[Snertz]

Nah, most likely your trigger return spring isn't long enough, or heavy enough to return the trigger. Best fix would be to replace it with one that was longer/heavier, then tune it from there.

(What marker is this trigger on anyway? Impulse I assume from your sig..)

[pbcustom98]

i fixed it actually..messing around with the trigger return spring and the trigger stop did it.

Thanks
Daniel