E-mag issues

[darwin]

so i belive i have all the magnets you can have in your trigger and its just right.. but if i am not careful it shoots to fast and kills the balls in the barrel, i am going to try to stick my wrap on it and see if it helps but the revvy seems to not be feeding..

another question.. in mech mode when i pull the trigger i get a good bit of travel before it fires. how do i correct that?

also i belive the electro stuff is fried. can i just send it all off to agd. and will a lvl10 fix the ball breaking problem i discribedearlier

[zeke1975]

LX should solve your chopping problems. When you say travel do you mean that the trigger does not use the stop you set? if so the trigger stop only works for e-mode, in mechanical mode the trigger just hangs free just like a standard mag.

Hope that helps!

[darwin]

its hard to explain. no in mech mode its fine. but i get half way throught the trigger before it actually fires. Its not so bad now but basiclly i want a hair trigger. I dont know if thats possible in mech mode..

Should i just get the LX or go with a whole new vavle? Is there that much differnecee

[Dayspring]

The magnet in the trigger itself determines where in the stroke the gun will fire. In electro, you can get close to a hair trigger. In mechanical, you cannot.

As for "all the magnets..." you mean up top in the gripframe? B/c you can considerably lighten your trigger pull if you use 1 magnet and an oring in there. If it's shooting "too fast" your trigger rod may be too close to the trigger and giving you problems.

As for the "killing balls in the barrel" what is it doing? Chopping? Barrel break? Cuz they are two different things. A level 10 will stop chopping. Won't do anything about barrel breaks. That's a paint issue. It's either too big for your barrel or it's too brittle/crap paint.

Why do you think the electro part is fried? Does the LED give you weird characters when it boots up? If that's the case, the magnet in the trigger is too close to the sensor. Back the trigger manget out a pinch and it'll work.

Grab up the Level 10 bolt kit and see what problems that solves.

[darwin]

Originally posted by Dayspring
The magnet in the trigger itself determines where in the stroke the gun will fire. In electro, you can get close to a hair trigger. In mechanical, you cannot.

As for "all the magnets..." you mean up top in the gripframe? B/c you can considerably lighten your trigger pull if you use 1 magnet and an oring in there. If it's shooting "too fast" your trigger rod may be too close to the trigger and giving you problems.

As for the "killing balls in the barrel" what is it doing? Chopping? Barrel break? Cuz they are two different things. A level 10 will stop chopping. Won't do anything about barrel breaks. That's a paint issue. It's either too big for your barrel or it's too brittle/crap paint.

Why do you think the electro part is fried? Does the LED give you weird characters when it boots up? If that's the case, the magnet in the trigger is too close to the sensor. Back the trigger manget out a pinch and it'll work.

Grab up the Level 10 bolt kit and see what problems that solves.

yeah i plan to i was thinking about just doing the whole vavle

its choppin not barrel breaks. Its the same setup i normally use but now i am tweekin the gun. As for the board the board has a circit on its thats actually fried.