when i installed my ULT it messed w/ my LX a little bit, now it leaks out the front when i hold the trigger and it seems to leak as i pull the trigger...what to do...? thanks for yur help in advance guys
-
-
When you hold the trigger does it leak for very long? Sometimes the residual pressure in the chamber will leak for a bit when the trigger is held. It is very minor and should stop after a moment. If it continues, then you may have to remove a shim from your ULT setup.
The issue of the gun leaking out the powertube while pulling the trigger can be fixed by removing a shim. The problem arises because the sear tip pushes the bolt back slightly during a pull. If the vent hole is just on the edge of the carrier o-ring, then any movement back will cause a slight leak.Except for the Automag in front, its usually the man behind the equipment that counts. -
it leaks for abut 4 or 5 seconds...and which should i remove a shim from the LX or the ULT, im assuming the ULT cuz if i remove from the LX it will throw everything off even moreComment
-
The shim to remove is a powertube shim. It won't throw anything off in your level 10 setup. Most people don't even use shims.Originally posted by athomas
The issue of the gun leaking out the powertube while pulling the trigger can be fixed by removing a shim. The problem arises because the sear tip pushes the bolt back slightly during a pull. If the vent hole is just on the edge of the carrier o-ring, then any movement back will cause a slight leak.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
my bolt will not reset itself if i take out shims...and the carrior isnt too tight, it is fitted properly, i dunno what to do, i guess i can try itComment
Comment