Automag RT leaking down the barrel with lvl 10 AND the orginal bolt

[Espens]

The leaking stops when i hold down the trigger, have checked the carrier o-rings but they are fine.
Ill get the same leak with the lvl 10 and the orginal bolt any suggestions?

[ChucktheMAGician]

Welcome to AO! Have you tried using the next smaller carrier w/ level 10(while using the same powertube o-ring, the white one that's inside the carrier) or a smaller powertube spacer w/ level 7?

[jewie27]

Forget about the level 7 bolt, and fine tune the LVL 10. Use the biggest carrier that does not leak. Put the backing washer in the Power Tube first. Then put the carrier with the o-ring inside. (O-Ring Down) Then put the new PT Tip on with the new Superbolt II and the medium or long spring. If the long spring works, use that one. Turn the velocity up a little and it should be ok.

[Espens]

Hmm sems like the leaking come from the trigger and not the barrel heh.

Edit: Ive just replaced to o-rings on the banjo bolt, maybe theyre not the right size?

[Espens]

Tryed different o-ring in the bolt but didnt help.
Checked and oiled the on/off o-rings didnt help.
The leaking come from the trigger frame and stops when i hold down the trigger.
Any more suggestions?

[athomas]

Replace the big o-ring around the bottom outside of the on/off assembly.

[jewie27]

Leaking LVL 10 and &?

why the heck are you trying to use the original level 7 bolt with the new level 10 parts? you can't do that, use the new Superbolt II and new carriers and o-rings. if it leaks try a smaller carrier and start with 2 shims.

[Espens]

Im not useing the orginal bolt with the lev10 parts.
Ill get the same leaking with the orginal bolt with the orginal parts and with the lvl 10 mod