Front frame screw for old style Iframe help

[Aegis]

None of my front frame screws or even cap screws will fit on this old Iframe - the flat where the screw head seats is SMALL. Any ideas?

[ZAust]

thats weird brian.. i have an older i frame and it fits the normal screws fine... id say just go down to the hardware store for some trial and error.

[Aegis]

actually, I think the frame was not machined properly. The trigger housing starts to curve down before the edge of the screw hole. Bad pic on the way:

[Tunaman]

They are all like that. The screw doesnt have to be that tight to make a difference. I dont loike the look of that taper on your screw tip. Get the right screw with threads all the way to the end.

[Aegis]

Wish I could get a better pic. The frame starts curving up about 80% of the way across the screw whole. I have two other Iframes and they both have a nice flat surface for the screw head to seat flush all the way around.

Think this one is going back.

[automan39]

mine looks just like that. its how they are made as tuna stated. if you want you can get a small washer to fill in the gap