revy just wont stay on my warp

[frost]

ok my revy just wont stay on after about 3 mins of use it falls off my warp ive would tape around the neck my revy but it still comes loose any help would be great

[LaW]

You got pm

[DWOOD]

i am wondering to how to keep a revy on a warp good

[LaW]

you need a feed neck spreader... dye makes them and some other companies do too.. they are little collar like things you put in your feed neck of the revvy to spread it out a little so it fits nicely.

[personman]

Drill a hole in your hopper so your hose goes through, like I did on mine. There are instructions here. It also helps keep your hopper close to the gun.

Or you could do a sandpaper mod, like Load SM5 did on his warp feed. He glued a piece of sandpaper in his warp shell.

Or you could buy a hopper spacer, like LaW sugessested. Electric tape should work though...

[lamby]

The sand paper mod works, and so does "friction tape" that you can buy at any hardware store. losen the screws for the warp push in the revvy with friction tape on it. Screw the warp tight and you are done.

remember the K.I.S.S theory.. no need to buy anything
(keep it simple, stupid if you have never heard that before)

[Evil1]

My friend had the same problem an electrical tape worked fine.

[rikkter]

if you dont want to buy anything, dont wrap tape AROUND the neck. it'll just push the tape up when you shuve it in the warp.
place a piece of tape so that one half is going in the warp, and the other half is sticking above, then just fold that down and shuve revy in.
but if you insist on wrapping it around the neck, just wrap it around and unscrew the screw nearest to the neck on the warp, and just place revy in, then tighten warp back up.

[cheetah256]

i just put a small piece of masking tape around the inside of the warp, opened it up, set the revvy in, and cranked it down. i can hold my gun by the hopper and shake it, and it doesn't budge.