level 10 or Flatline??????

[ciscokid]

I recently rebuilt my flatline all new o-rings exc.I also increased the psi output to 900+ psi(was around 750psi)...my e-mag valve w/level 10 started to leak a little so i backed out the valve just a hair and it stopped..but now when i try to rapid fire, i cannot, i seem to burp it, the rt- is not as reactive at all.Also when i look at the psi gauge it actualy drops down to around 450+ psi befor kicking back up to 900+ psi...if i rapid fire it never quite makes it out of the 600-700 range..ive never noticed that befor maybe all flatlines do that? or is it that i need to adjust the level -10 to handle the new increase in psi? If somebody has some answers id really appeciate it.

thanks
cisco

[Dayspring]

Check/clean/replace your flatline reg seat. Also, make sure you put it in the right way.

[ciscokid]

?

I placed a new reg seat but how would it be placed wrong? isnt their only one way to place it?.also are you saying the psi is not suppose to fluctuate that much?

cisco