I know that the x-valve is basically an aluminum RTpro, but it seems they use different o-rings. I think my powertube tip o-ring is shot, so I want to buy another one. But, I don't know what this o-ring would be called, since it goes on the lvl10, and the RT parts kit doesn't take into consideration lvl10. So basically, what do I buy to replace x-valve o-rings? Does the RT parts kit give all the CORRECT o-rings, or what do I have to look for?
-
-
The X-Valve needs a Level 10 Carrier O-Ring instead of the power tube o-ring. Do keep in mind, if it's just leaking, you may want to try going down a carrier size before replacing the O-ring, as they do have wear in.Automag RT-Pro
68 Classic
BE 1999 Rainmaker
PMI Trracer
So many guns, So little time. -
Comment
-
It should be, if they say so.Automag RT-Pro
68 Classic
BE 1999 Rainmaker
PMI Trracer
So many guns, So little time.Comment
-
Great, so I can buy a $25 pack of stuff and only 2 o-rings work? Slowly but surely people are helping me out here, but come on, someone has to have a direct answer to the rest of the kit. If I want to replace the x-valve's o-rings, is the RT kit worth it or not? What works and what wont?Comment
-
I was in the same situation as you and ended up going through the AGD store and picking out the parts one by one.It's not to bad really and came out to under $20 for multiples of each item.
Just go to the exploded R/T diagram as a reference and don't forget the on/off X-ring if it's an E/XMag.That and the L10 orings should get you there.
Jay.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
-
He did say "Power Tube TIP" oring right? This is an oring that almost never wears out. I have them if you need some. Email me.
Comment
Comment