this may seem like a stupid question but how do you put the ult in the x-valve
-
Top 10 Reasons to Date a Paintball Player:
1.We aren't afraid to get down and dirty
2.We know how to listen to directions
3.We at least have a ten inch barrel
4.We always wear protection
5.We love to be aggressive
6.We like to push hard, but not hard enough to get hit
7.We clean our barrels a lot
8.If we run out of air, it takes less than 5 seconds to get us going again
9.We're good at moving our fingers extremely fast in small places
10.We can move and contort our bodies into weird positions
Hard Work Often Pays Off After Time, but Laziness Always Pays Off Now. -
He ya go buddy go here. http://www.automags.org/forums/showt...threadid=96538
By taking out ur feild strip screw u will find that ur vavle comes out.
when u take out ur vavle u will see a brass looking thing.
Pull that out and put in ULT In the hole.
In the link above u will find how to tune that.AGD MiniMag
-Y-Grip
-Emag Valve
-LVL10
-ULT
-NitroDuck 68/3000
AIM Name: SpdElemts
My Feedback
Pics.
Comment