Getting my sear to trip with no air?

[Branchvillian]

I am always working on my trigger for something, and whenever I try to get it perfect, I have to take it off the body, bolt, valve, etc. and change what I need to change, then put everything back together, and gas up to make sure it shoots how I want it too. Is there any way for me to get the electronics to activate, and trigger the plunger WITHOUT having air in it? That way I can mess around with whatever I need to get perfect, THEN install everything back on the gun.

[Dayspring]

Sure. Just put the safety on.

The electronics will fire the gun with or without air. It's easier to hear the solenoid click if the safety's on.

If you need to take the rail off, put your thumb underneath the sear at the back. This'll allow the 'noid to pull the plunger.

Plus, with the 3.2 software, you have the trigger test mode. It'll show if the HES is triggered or not by displaying a "Trigger on" or "Trigger off" message on the LED.

[Branchvillian]

Well, I don't have a saftey unfortuanatly
As for 3.2, my gun is on it's way to Tuna right now to be flashes from 1.37 I can't wait to get it back!!

[Dayspring]

Well, while it's there, ask him to put the safety back in.

DUH!

[Branchvillian]

How much do you think that will cost me, because I already sent him the package, would it be extra?

[Dayspring]

Sadly, I can't read Tuna's mind.

Asking HIM might work better.

Originally posted by Branchvillian
How much do you think that will cost me, because I already sent him the package, would it be extra?

[Branchvillian]

Sorry, I was under the assumption that you guys where the telepathic blood brothers of AO.:)
I'll E-Mail him now I suppose!

[Tunaman]

I'll put one in for ya...no problem...