Ok i have a warp intellied to my Emag. It wasnt spining enought to load for each shot with 4 jumpers, yes they are verticle. So i removed 3, so there is just 1 jumper. Spins the same distance. A little less that 1/4 turn no matter what # of jumpers i put in. Batteries are fresh. Any idea why this is happening? Bad board?
-
-
It spining in the right direction, so i doubt it.Comment
-
I need to go back and read the thread but that jumper is near the intellied jumper. It needs to be on a certain set for the emag intelli. Here's a quote from one thread I have saved. I was mistaken it's a jumper for sensor not intelli.Originally posted by Havoc_online
you pulled the wrong jumper bud. the bottom is vib., mid is pos., top is neg.
in other words, leave the mid, pull the bottom(so the only jumper is on the mid, nothing on top either)
hope this helps
Comment
-
Yeah polarity need ot be moved form + to - to make it spin the right direction for the emag. I've done that, but isn't that unrelated? maybe im wrongComment
-
It may be, I've never had mine set up on the wrong jumpers so I was just guessin'. That's the only thing I could think of and considered not posting it but sometimes it's the things that don't seem like they're the right answer that are the right answerOriginally posted by andrewnelles
but isn't that unrelated? maybe im wrong
Good luck, you might wanna PM Havoc_online, here's his warp thread if you haven't seen it, http://www.automags.org/forums/showt...threadid=50487
Comment
Comment