I just recieved my new intelliframe today, and am trying to install it on my minimag. However, I can't figure out where to put the spring that goes into the grip assembly? I know I have to use it because otherwise the trigger will just push and it wont return. BUT, I can't figure out where I am supposed to put the spring? Any help here? I am talking about the around an inch long spring that goes under the whole sear/trigger assembly, and keep the pressure against the on/off and keep the trigger returning after you fire. Any help?
-
there is no spring in the intelliframe...
you dont need a spring to return the trigger on an automag- the return pressure on the trigger rod pushes your trigger back.Yummy yummy yummy, I've got fun in my tummy.
-
So then why do I need the spring in my current grip frame?
This is an old-school minimag by the way.Comment
-
Dunno, but you don't need it in the intelliframe. :)
What kind of triggerframe is it? Benchy? Dye?Comment
-
-
im lookin at my old frame right now (stock carbon fiber AGD one) and there is no spring. just the trigger assmbly., set screw for the safty, and the safty- no spring or anything like that. your intelliframe doesnt need a spring
just pop it on and go.Yummy yummy yummy, I've got fun in my tummy.
Comment
-
i know what you re talkin about, trust me you dont need the spring :)
I do know the AO sig rules, I just want a free sig pic, that's all! :mad:
My Gun CollectionhAppy's Official B/S/T thread - FeedbackComment
Comment