I just got my Micro-emag. It came with the 3.2 software installed on it (from AGD). I don't have any air to test it out, but I juiced up the battery and was working the trigger a bit. I noticed that if I depress the trigger in any of the modes (M,E,H) the gun will go into full auto. Is this the 3.2 problem, or will this be corrected with the addition of air to the gun?
-
Rooster "But such is the mentallity of the Arab people. Which is why as long as there are Arabs, there will be a terrorist problem."
^^^ known AO racists
Contact Info
AIM: holsamoht
e-mail: [email protected]
My Feedback -
You need to swap the orientation of the solenoid wires on the board. (Long story short- the HES is picking up residual magnetic fields from the 'noid and is going into a loop. By switching the noid wires, it changes the orientation of those fields.)
Reference this thread for further info.
-
Sigh, I know how to fix it, what I don't know are the symptoms to warrent fixingRooster "But such is the mentallity of the Arab people. Which is why as long as there are Arabs, there will be a terrorist problem."
^^^ known AO racists
Contact Info
AIM: holsamoht
e-mail: [email protected]
My FeedbackComment
-
Full auto. THAT is the symptom.Comment
-
okok, thanks, just wanted to confirmOriginally posted by Dayspring
Full auto. THAT is the symptom.
Rooster "But such is the mentallity of the Arab people. Which is why as long as there are Arabs, there will be a terrorist problem."
^^^ known AO racists
Contact Info
AIM: holsamoht
e-mail: [email protected]
My FeedbackComment
-
curious as to why AGD does not check for the 3.2 bug before shipping the gun back out? Like stated it can be done without air.Comment
Comment