what is the best way to get a teflon taped macro line fitting off
teflon tape
Collapse
X
-
use the allen wrench in it, like how u got it on.... or a cresent wrenchshe seems fond of eating hellfire, which would be a first out of anyone ive seen eat it.-Kaiser Bob
AIM: idiothasagunX
Email:[email protected] (i dont check email, but im always on aim) -
well you cant use an allen key on it if it is a 90* / elbow ... only straight fittings come off like that
i suggest a 7/16th open wrench ... or a cresent wrench
Where did the Old AO go?Comment
-
got it off with one of those screw wrenches and I put my tank on my cocker went out side was turning down the in put pressure and then BOOM the adjuster flew off and the piston flew into my thumb and I had to go to the hospital it hurt like a @#$%^& !!!Comment
-
for got to say that the piston is lost in the grass some were which sucks I had bad luck todayComment
-
-
it was all torn up on the under side and was bleeding pretty badly for my thumb I have like this tinny cast thing on it and am suposed to take it off tomorrow it was really just a couple of small holes maybe 10 to 15 small gashes, what really frightened me was the loud boom it sounded like a 12 gauge shotgun was fired 3 feet away well really it was 600psi coming out of the tank all in one tiny hole really tinyComment
-
-
thanks I will here is a link to what happened to me all today http://www.automags.org/forums/showt...hreadid=117501Comment
-
if it makes you feel better i hurt my knee when i dove into the snake at FBM today .. apparently one of their bunkers lost a metal stake .. and my knee found it
Where did the Old AO go?Comment

Comment