So I have myself a Warp Feed that has room for 2 9volts but because the previous owner installed an on/off switch, I can only really fit 1 9volt in there. The warp itself is set up to run on 1 9volt anyhow.
On to the hyperframe. I will be recieving the frame in the mail in about a week and plan on replacing the microswitch and doin the mod to make it lighter and shorter.
What I do need to know is, should I invest in a 9.5volt recharge battery or will I be fine with a 9volt battery in the grip of the hyperframe?
Also, are they any "plug and play" mods for running the hyperframe and Warp together? I dun wanna go soldering this and that due to the fact that I'll probably burn something and don't have the funds to replace any burned out electronics.
thanks for the info..
On to the hyperframe. I will be recieving the frame in the mail in about a week and plan on replacing the microswitch and doin the mod to make it lighter and shorter.
What I do need to know is, should I invest in a 9.5volt recharge battery or will I be fine with a 9volt battery in the grip of the hyperframe?
Also, are they any "plug and play" mods for running the hyperframe and Warp together? I dun wanna go soldering this and that due to the fact that I'll probably burn something and don't have the funds to replace any burned out electronics.
thanks for the info..
Comment