Building a Mag...

[joebob09]

im in the process of building a mag. I using a ule body witht eh body rail and a y grip trigger. For the internals im going to use a lvl 10. does the lvl 10 act as the bolt or do you need another bolt to go along with that.. what other internals do i need?.. if any.

[Toranaga]

Do you have a valve?

[joebob09]

no i do not

[Branchvillian]

You need a valve. Since you will be buying the lvl 10, you might as well get the X-Valve, because it comes stock with the lvl 10. You still need a sear, and a sear pin. You also need a barrel.

[joebob09]

what does the x vavle do exactly?

[Branchvillian]

It fires the marker. It's an RT valve, but lightened. It pushes the trigger up after every shot. The good thing is that it comes stock with the lvl-X.

[joebob09]

what other vavles are there?

[Branchvillian]

AN RT valve, but that does not come stock with the lvl 10, and it is heavier.

[joebob09]

so i can buy a x valve with the lvl 10 bolt.. how much is that?

[Branchvillian]

Check the airgun store, but I know it's a little bit over 300 dollars. Sounds like alot, but remember that it comes with a 100 dollar lvl-x kit as well.

[Colangela]

i just did the same thing... the x valve comes with the level 10, which is a bolt, yes.. it also comes with a sear, u still need a sear pin and dont forget screws..
i have the y grip and ule body i reccomend them both.. benchmark makes a nice body rail..any other questions feel free to ask me

[joebob09]

ok so buying the x valve is the best way to go then i see... and all ill need after that is the sear pin ok i think thats all ill need to know.. the barrel is no problem i got that taken care of.. oh, on the rail ill need to take that barrel lock system off right? or does the benchmark not have one?

[joebob09]

is there any place that i can get like a diagram or instrustions or something for this? i can build the body i think but the internals may be a little different...

[tonybhall]

get a custom ule and build off that

Hey Joe,

I know you said you want to build your Mag, but if you are going to buy the x valve for $300.00, why not just get a custom ule mag from the agd store? It is a complete marker that comes with the x-valve and level 10 factory tuned and tested all for $399. The best thing is that you can add custom features for less than you can buy them for seperatly. Like the ULE Trigger pull kit for $19.00. The ULE main body is only $20. It also comes with a J&J barrel at no extra charge for the ULE Body.

You may come out better this way unless you already have several parts. I ordered mine last week and expect it to come in today. If you would like I can let you know what I think of it.

Good luck.
Bryan

[Colangela]

u have to take the barrel lock system off, its pretty self explanatory when u look at it, just inscrew the screw and it comes right off