ULE mainbody question

[tonybhall]

This may seem like a dumb question but I have never had a marker with a verticle feed. I just got a custom ULE RT with the ULE mainbody. How do I get my egg hopper on it.

The neck of the hopper is way to thick to fit down into the feed neck. Do I just sand down the egg neck? And if so, any suggestions on the best way to do this? One you get it to fit, what holds it in?

Any info on this would be appreciated.

Thanks,
Bryan

[Dayspring]

Sand down the feed neck on the hopper, just not too much.

And friction keeps it in.

[Evil1]

Do the ULE bodies on the new RTPs have a different diameter feedneck? My egg fit into my ULE body pretty easily and my body was just purchased in october.

[tonybhall]

I don't know if the feed neck has changed or not. It could just be my egg. Who knows? I will try sanding it down till it fits. Any suggestions on what type sand paper works best on plastic and is there an easier way to do it than by hand?

thanks,

Bryan

[kenndogg]

use rough/large grit to sand it down faster and fine grit to smooth it out when your done. do a little at a time so to make sure you don't over sand it.

[Catfish2850]

Bryan,I emailed you some info.