RT valve backing out during fire!!!

[i-luv-my-rt]

While i was shooting my Emag i noticed it started to leak out of the seperation of the valve. I grabbed it and twisted and it turned about 1/4 inch. I was wondering if it was ok to teflon tape it. I just want to make sure so that i dont break anything. Better to ask now than to pay later.

Thanks!!!

[FaSSt]

I don't think you should have to do that. Mine is on finger tight (I used a piece of leather to grip it well), and it yielded zero problems so far.

[BlackVCG]

You need to make sure it has the roll pin in the valve body. That prevents it from backing out too far. Go ahead and replace the reg. valve body o-ring after making sure the roll pin is in place.

[i-luv-my-rt]

Alright thanks guys!!!

[Cha0tic]

my mag did that, but i replaced the o-ring that goes around the reg, and it was fine from there on.