Intellifeed To Revvy, I Need Help!

[captain stabbin]

Hi, you all have been great in helping me with my mag problems, since i am the new, proud owner if a pretty ule mag. For some reason i can't download the AGD manual on how to connect my intelliframe to my revvy, so can anyone explain it to me>!! Or does anyone have a link to a page where there are illustrations with descriptions. Please leave me a list of materials i need, so i can go to radio shack and pick up what it is i need. Get back to me guys, thanks a ton.

[nate2k191]

[nate2k191]

(twisting the cut wires you exposed on the male end of the earphone cord onto the switch)

[nate2k191]

(putting the switch in the frame, when you put your sear in make sure its hits the roller switch well)

[nate2k191]

(cutting the grip so there is room for the wire)

[nate2k191]

(open view of hopper in order [board, motor, eye]. This picture shows the wire installed, as you can see)

[nate2k191]

(cutting into the red wire, make sure you dont actually cut the wire, just the insulation, so you can join the white wire from the earphone cord with it)

[nate2k191]

(wraping the black wire around the metal prong under the board, opposite to the revy on/off switch)

[nate2k191]

(lead the earphone wire through the notch you cut in the revy plastic and close it up, make sure you dont pinch any other wires. the connect the plugs!)

For any questions or more picture, pm me

[captain stabbin]

thanks alot nate, ill try to do this by myself, im horrible with wire work though hah and this seems just a litttttle too complicated, but ill give it a go.