so yeah... i dont know anything about mags... little help please

[elpimpo]

ok so yeah ummm my 68 doesnt shoot. i made sure all the parts were there and im missing an oring. (the small one on the bottom of the on off assembly) but any ways i get pressure to the trigger pin and everythign but it just seems like its not going far enough. i adjusted my pin to the 1.98" or whatever it is but i may have gone from the wrong point for messureing. i dont know. so a little clarifacation on where u measure from would be nice. and also why the heck it woulnt shoot.

[Dayspring]

Measure from the front of the pin to the clevis where it attaches to the rest of the sear assembly.

Replace that missing oring and turn up the velocity a bit until it shoots. (Don't go ALL the way in, otherwise it'll vent out the back.)

[elpimpo]

actually i turned it all the way in and it didnt vent. is that a bad thing. also the clevis would be in front of where the joint is

[Digits]

Well first of all replace the o-ring.. And ya I'd say crank the velocity up.. But if you've done that already and it still doesn't shoot then I dunno.. It's probablly just the o-ring though

[elpimpo]

thats so freaking gay that that one little oring would stop it from shooting. you would think it would still shoot and push the trigger rod back into place

[Digits]

.. I guess.. But if you don't have an o-ring on your tank it doesn't work.. This isn't much different..

[elpimpo]

ok so i got the o ring replaced(actually i found it) and i examined all my orings and they are all good. i looked at the diagrams for all my stuff and its all together right but yet it still woulnt shoot or even return the trigger pin. what do i do

[eddie885221]

BOLT STICK!!!!!!!!!!!!push the bolt back til it clicks after u gas it up

[elpimpo]

i dont know how but i got it to work. its a miracle