I have a 68/3k pmi screwin tank. I just got a cp on/off asa and noticed something after i started using it. My tank would leak a bit after i took it out. If i pushed the pin the right way, it would stop leaking, but when i let go it comes right back. Is this the fault of the asa? Is there any way i can fix it?
-
Feedback
Upgraded Minimag F/S F/T
My Mags:
-Blue ULE, Xvalve, intelli, blue cp gasthru and flame drop, black and blue cp 2 piece
-Minimag, gas thru and taso drop with on/off, stock barrel
Good Traders: Serialthriller, Heftylefty, Doctorstox, -=[ DevNull ]=-, d40winker(from PBN), bensongg, pbcustom98, nouseforname -
upFeedback
Upgraded Minimag F/S F/T
My Mags:
-Blue ULE, Xvalve, intelli, blue cp gasthru and flame drop, black and blue cp 2 piece
-Minimag, gas thru and taso drop with on/off, stock barrel
Good Traders: Serialthriller, Heftylefty, Doctorstox, -=[ DevNull ]=-, d40winker(from PBN), bensongg, pbcustom98, nouseforname -
Could have bent the pin. Might need a little lube. Also you might have the on/off open to much. Mine if a screw it down all the way will acctually plug the tank and prevent air going into my gun. Just open it enought to get all the air you need."Your just a myriad on inner conflict aren't you?"
Good Traders: deathstalker, Der Cockermeister, Target, brtncstm160
Bad Traders: None, yet..........
"I have to think of some creative quote to put here don't I?"
Feed Back:http://www.automags.org/forums/showthread.php?s=&threadid=119588Comment
Comment