intellifeed double firing?

[Joemafia69]

hey, has anyone had a problem with the AGD intellifeed frame double firing on them? I am not sure if i am just not used to the extremely short trigger pull or what.
Thanks
Joe

[Cha0tic]

has your trigger rod been adjusted from the stock setting? if so, turn it back.

[Joemafia69]

No, i haven't done any type of trigger job or tried to adjust the length of the rod, it just seems extremely sensitive....

[PyRo]

When the gun is gassed up is the trigger rod hitting the trigger if you pull it all the way foward?
When you go from a single to a double trigger it could just make it seem to be lighter.

[Joemafia69]

it does hit the trigger. I had a double before, the benchmark, it seemed like there was a little more play with that tho

[PyRo]

Your trigger rod may need to be backed in a little bit if it hits the trigger while it is pulled all the way foward. Have you ever messed with the rod before when you put the benchie on?

[Joemafia69]

nope, it came straight out of the box as is

[Ityl]

I don't think the trigger rod would have anything to do with double firing. And is this on a reg mag or a RT(PRO)?

[Joemafia69]

It is an RT Pro

[PyRo]

Look for worn sear-bolt as well.

[Panzerr]

Change your on-off pin.