benchmark is shortstroking

[brett]

i love my micromag but in rapid fir i end up shortstroking and the ball only goes like 4 feet but i can shoot the autococker flawlessly that has a hinge trigger so if i was to get a rt micromag with intelliframe would it work better kinda like the autococker?

[jah871]

it will work better but u still can short stroke with it. if u want to take all chances away of short stroking get an electronic frame like the hyperframe. u will be paying a little less if u went with it then buying an intelliframe and retro.

[Smoken]

... but IMO you end up wityh a much more reliable gun if you get the inteliframe and retro valve. My friend has an RT Micro and, while you can short trigger it, it is far more difficult to short trigger it than with your current setup (my dad has your setup). Also, If you get the AGD stuff you get their great service, which you may not get from a company that makes the electro-frames. But, it's your money and I'm not sure what you like best. See if you can try both of these setups before you spend several hundred dollars on one of them.

[jah871]

i also like non electro guns. i just suggested an electro frame because it gives him the ability to virtually eliminate shortstroking.

[brett]

thanks for ta advice and i already got a bushmaster so the electro end is covered i just want a good semi (or rt)

[[NA]WARLORD]

.....Or you can remove the trigger on your benchy, drill a small hole in it, and add a set screw to it as a trigger stop. this will help you stop short stroking, and save you a great deal of cash in the long run. Good Luck!!!!!!!!!!!