Hyper Frame BPS help??? NEED TO KNOW ASAP!!!

[nato]

ok, I changed it to 50 to be safe... again I still dont know the consequences of having lower numbers and such...

as for the rof cap, the FAQ didnt talk about changing the rof. And right now my hyperframe is firing much less than 13 bps so if it is capped then its below factory stock.

I took out my valve after shooting a bit and wasnt sure about this and was a little concerned... I want to do this right, not make a $70 mistake.

I wont fire the marker untill you get back to me to make sure Im not screwed or in the process of screwing.
N.A.T.O.

[nato]

One more.

N.A.T.O.

[Digits]

I've never had that on my bolt from firering my hyperframe, be carefull

[hitech]

[nato]

Im a little confused... what exactly should I double check? Can you tell me exaclty what to do... change noid set screws, direciton something should be, the spacing? Im just confused all together.

Other than the wear the gun was firing great minus the bps...

As I have said before I only have semi on my board and dont have options for burst or full-auto. The 1st part of the menu does have the letter F followed by a # (ranging from 0-19) I have it set at 19 right now and its really slow.

Again I wont fire the marker untill I know exaclty why this wear is occuring...

N.A.T.O.

[hitech]

You need to make sure the sear is latching all the way. With the grip panels off air up the marker. Pull back on the solenoid disk. Look in the half circle hole at the sear leg. There should be a small gap there. If there is, press on the sear leg toward the solenoid through the safety hole. It should NOT move. If it does, the sear is not latching all the way. Normally that would indicate an on/off pin that was too short. With the ULT I can't say (never used one). If there is not a gap, you MUST adjust the solenoid position (the 4 VERY SMALL screws on the top).

Also, use the shortest spring in the level 10 kit. Once everything works properly you can try changing springs.

As for the ROF, I'm not sure. What kind of ROF are you getting?

[nato]

Thanks, I will test in the morning. As of now my rof is about 5 - 7 bps. blech!

Again I appreciate your help.

N.A.T.O.

[nato]

As I expected the sear leg IS moving forwards towards the noid. Also when I aired it up the marker was leaking slightly down the barrel due to the sear not latching. Th only way to hold off the leak was to hold the lvl 10 back the whole time (it wouldnt latch). This would also explain as to why my gun would fire one shot right when I aired it up even if i didnt pull the trigger. I already have the long spring installed and im wondering if you think the conclusion would be to move the whole solenoid forward more.

N.A.T.O.

[hitech]

Moving the solenoid might work. It's hard to tell without seeing what is happening. The one thing I'm sure of is that you MUST get the sear to latch all the way. if you do not, the bolt and sear will wear. It's not going to work correctly until that is fixed.

Sorry I can't be more help. Some things are hard to troubleshoot unless you can actually work with it.

[Digits]

.. I can let out a string with my hyperframe, but then after that the bolt does not go back far enough for the sear to latch, what should I do to fix this?