First time with a mag, and I am at a loss of words

[Aegis]

What is the difference in cost between a LX kit and a spacer kit?

[Inoculation]

Thank you for the offer tuna, as for the cost difference, the spacer kit is around $15 and it's $225 for the valve swap from AGD so there is quite a difference in the deterioration of my wallet lol. I gave it to a buddy of mine that is familiar with the L7 valves, if he can't figure it out I will be forced to take some drastic measures........

[sniper1rfa]

an overlooked factor.

Check the ball detent of your barrel (shoot without the barrel, see if it works).

Sometimes, if you have a wire detent (nubbin), it will bend and catch the bolt.

Replace it with a plastic one if you havent already, just to be sure.

[danheneise]

Originally posted by Inoculation
Yeah I'm messing around with the rod length right now.

there should be a space between the trigger and the tip of the rod of about a credit card's width, if it's touching the trigger i could see that as being a major problem. i can't remember the measurements off the top of my head for the rod though

[Inoculation]

Thanks to all that left a response! I have corrected the problem. It seems that I had installed the o-rings and left 1 sitting on my bench lol. The small white one that goes in the valve under the on/off trigger pin. I placed it inside relubed it up and now it works like a champ!

[Tunaman]

Originally posted by Inoculation
Thanks to all that left a response! I have corrected the problem. It seems that I had installed the o-rings and left 1 sitting on my bench lol. The small white one that goes in the valve under the on/off trigger pin. I placed it inside relubed it up and now it works like a champ!

Just a tip for future reference...
When installing the on/off assy into the valve, put the white teflon oring ON the pin and then push the entire on/off assy into the valve. You will get a little "click" when it goes all the way in...and that click will insure it went in right.