Barral & Paint' need help

[spectra260]

I bought a RT while back and finally got my lvl 10 to work on the gun. It came with a dye boomstick 14inch barral and the stock barral.

I was wondering what paint do I want to use with my boomstick on my rt? Im not sure of the bore size but on pbgears website it says boomsticks are .688

I use marbs with my angel and the barral is the same as the paint bore, .687 and they seem to work great. I could put a paintball into the barral and it wont just roll thru the barral but on my rt/boomstick the ball just rolls right through the barral. So I was thinking its proble better to have it a lil snug but I cant find any paint thats .688, I can only find .689 and that proble would be to tight in the barral and decrease the fps.

So my question to you guys is, what do you think? What paint do you use with your boomstick, etc.

Ive tryed marbilizer in my rt and the paint doesint hit the same spot repeatly like my my angel does but I dont know if thats because the gun had oil and stuff from after installing lvl10. I have to check it out after shooting a bit.

[spectra260]

Oh also, has anyone found the best paint to shoot with the stock barral? And what is the bore size of the stock barral?

[Mag_SEAL-6]

Barrel is spelled w/ an e. That's beside the point, I used to use inferno with the stock barrel, it was awesome. I know that inferno works well w/ my insert .689 insert on my freak but I don't know the exact bore size of the stock barrel. But inferno is awesome, so try that. Yeah, if the ball rolls out, use a different type of paint. A good way to check is putting a ball in the barrel, and if you see 2 spots of light then you're ok. Or if you can blow it out of the barrel w/ a decent amount of pressure (not to where you're blowing an ear out) then you're fine. Good luck.