input press ?

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • stupiddogg
    Marker Whore
    • Dec 2003
    • 571
    #1

    input press ?

    ok I have a emag, with a aa rapter reg and 88/4500 tank...

    how do you tell where your pressure is at going into the valve. yes a guage make sence, but there is only the tank guage and nowhere to mount one for out of tank pressure.

    there is 2 spots on the aa reg marked hi and low pressure, Is that where I should mount a guage?

    Thanks
    Last edited by stupiddogg; 01-25-2004, 11:33 AM.
    Tags: None
    • argnot
      I can do anything
      • Nov 2003
      • 725
      #2
      my guess is it would be low because if you think about it high would be the tank input and the low would be the presure after it would be regulated. Make sense to me.
      "Your just a myriad on inner conflict aren't you?"
      Good Traders: deathstalker, Der Cockermeister, Target, brtncstm160
      Bad Traders: None, yet..........
      "I have to think of some creative quote to put here don't I?"
      Feed Back:http://www.automags.org/forums/showthread.php?s=&threadid=119588

        Comment

        • epiphany
          Registered User
          • Jan 2004
          • 177
          #3
          the easiest way is to set it up with a gauge and then never move it use steel braided and also a pr connect i can trade you one or you can get on i am looking for a drop for that timmy
          TEAM EPIPHANY
          www.teamepiphany.tk
          sponsors REDZ STIFFI

            Comment

            • epiphany
              Registered User
              • Jan 2004
              • 177
              #4
              oh yeah the two spots you are talking about i am sure but those are the rupture disk
              TEAM EPIPHANY
              www.teamepiphany.tk
              sponsors REDZ STIFFI

                Comment

                Previous template Next
                Working...