LVL 7 average input pressure

[GT]

I have a classic lvl7. was thinking about running my conquest on it. I have run my emag valve w/ lvlx at 625 with no problems. Think the lvl7 classic can run <600?

[GT]

[ChucktheMAGician]

Re: LVL 7 average input pressure

Originally posted by gtrsi
Think the lvl7 classic can run <600?

Are you looking for guesses, kinda like a bet thing? I say go for it! I'm not sure if running it lower has any bonus or not tho?

[GT]

uhhmmmm,
I want to know if the input on my conquest will be high enough at 600psi, although I am thinking of ditching it for a crossfire..

[athomas]

A level 7 should be able to work at 600psi if you are running an efficient setup. It would also maintain a fairly high flow rate because you are maintaining a good pressure differential between the valve pressure(<400psi) and the output of the tank reg (600psi). A level 10 setup will work too if you use the small bolt spring. It will have the same chamber pressures as the level 7 setup.

[11_Mile_TMaster]

Well... Level 10 Requires MORE pressure than Level 7...

And, I'm looking at my Classic Diagram... it says it regulates the air down, on average, to about 375PSI.

That's enough for a 200PSI Differential. Barely.