removing x-valve/lvl10

[RingOfScale]

hey, i was just wondering, does removing the x-valve/lvl 10 mess up the tuning /adjustments on the lvl 10 ? if you took out the assembly the clean the gun, or whatever, would you have to retune it when you reassembled the gun ? i know this is a simple question, i am just an idiot :P

-RingOfScale

[CaliMagFan]

no... its deeper than that

the fine tuning for the LX and the ULTrigger are done inside the powertube and the on/off assembly-respectively... this is done with shims and carriers and so forth, so no... just pulling the bolt/valve out will do nothing to the tune of your marker... you'll want to oil it at least once every good weekend or so of play.

-kyro

[dyeforever]

No if you just removed the x-valve and re-oiled it it should slide right back in and work just fine.

if u changes the o-ring carrier then u might have a small leak problem.

[AGD Paint Baller]

dyeforever is right it would only mess up if u change the carrier or the o-ring in the carrier or the shims

[RingOfScale]

ok thanks ... thats what i was thinking, cause i thought having to retune the lvl 10 everytime u cleaned/oiled the gun woul dbe kinda stupid ... glad to hear that ya dont have too :)