L X spring snafu

[CaliMagFan]

ok..i have my ule custom all good and setup with the standard lvl 7 spring on the lvl 10.... it works fine.... but, yeah, i think the bolt is just a little too hard on paint, and i did chop one today cause i was trigger bouncing big time... so i installed the next spring which appears to be the red colored spring in the lvl 10 kit... i have 2 silver, one is the lvl 7 length and 2 are really close, red and silver, the red seeming to have 1/2 a loop cut off tho. i just installed the red spring and gassed it up.... nothing... nada... the trigger rod doesnt move out, i dont get a shot while putting the gas on.... i can crank the velocity up and down and nothing happens... i dont get why changing the spring did ANYTHING to my on/off pushing the trigger rod.... i can understand if you pull on the trigger and the bolt stays cause the spring is a lot harder... but damn, nothing happens.. all i know now is that i have the pain in the butt job of degassing a marker at 850 psi....

any help is apppreciated

-kyro

[abunkerer]

make sure that your tank is full. try to put the small spring back in, if it dosent't work then you need to oil everything and reassemble.
If the small spring does work, and you try the larger spring again, and it still won't work; then it is most likely your carrier being too tight/small.
-move up carrier sizes untill the gun leaks down the barrel and then go down 1/2 size, and use the same oring.
-make sure to oil everything
-keep your tank pressure above 2000

[nippinout]

Red spring is the middle one in the LVL10 kit. Try using the shorter of the two gray ones.