eggy wont fit, boo... help?

[paintpiggie]

what's the best way to make an eggy fit on my feedneck?

im sanding it right now. but i think that'll
decrease the toughness of the eggy neck.

any other methods?

[Dayspring]

Sanding is the preferred method for making it fit. So long as you don't crack it or go too thin, it'll be just fine.

[paintpiggie]

hmm, if you say so.

they do sell replacements for the beltway/neck,
right?

[krafty]

Raceway, yeah. About $12 for both halves.

[angelbeast24]

or just buy a different feedneck some necks r bigger than others i kno on my angel my kapp low rise fits fine for my egg.

[tonybhall]

You must have the ULE verticle feed

I had the same problem with mine. It took a lot of sanding. If you have a dremmel with a sanding attachment that would make it quick. It took me a little over an hour to do it by hand. It was a real pain. Just sand down a little at a time and keep checking the fit. You want it to be snug. I still have to work with mine a little to get it in but you don't want it to be too loose.

Of course you could replace the feed neck with a bigger one or an adjustable one.

Good luck.

Bryan