Emag not shooting in E-mode

[Rusto]

Just recently my emag wont shoot in E-mode. When i gas it up it shoots fine in mechanical. When i switch it to E and take the pin out it will fire once then it will not fire again. The board says its shooting, so the sensor is activating fine, so anybody have any suggestions?

[Halliday]

Move the trigger magnet forward a bit.

[Rusto]

Thats not the problem, i tried. Any other suggestions??

[SkyBoySurfer]

what version software are you running?

[Rusto]

sorry for not mentioning, ive got 1.37

[SkyBoySurfer]

is your battery charged?


when you test your shots i want you to put the E/M swich faceing the grip...so
its selecting blank.

how do you know it is decteing your shot?

and what is your air system..and how much PSI do you have left in your tank?

[Rusto]

I know its detecting a shot because the counter goes up with every pull. Battery is good and im using a pure energy HP preset.

[BlackVCG]

"Battery is good"

Are you sure? What's the voltage?

The solenoid could possibly be bad. Measure the internal resistance by putting the DMM test leads to the two solder points on the board and checking the resistance. It should be 3.0-4.0 ohms.