X-Valve Question

[MercuryCross]

I got a new X-Valve yesterday and gassed it up on my mag, i replaced the sear too on my intelli, but after I gas it up, when I pull the trigger the trigger an sear are really loose just as if I was pulling the trigger while the gun was not gassed up. I tried twisting the velocity adjuster several times but that did nothing, what do you all thik the problem is? I think it is the sear, should I extend the sear rod more from it's original position? I would have tried it, but I don't want to mess with anything that does not have to be tinkered with, AGD does not give you the best instructions on how to install upgrades...

[Z-man]

Sounds kinda like your tank is not sending air to your gun (or at least not much). Is it full or at least have 1,000psi in it?

[NeilS300]

Check to make sure you Macro-line or SS hoses are clean on the inside. Then make sure your tank is working fine(just push in the pin to make sure air is coming out). If its not any of those problems try cleaning out your regulator in your valve and cleaning the rest of your valve. Take you valve apart to make sure nothing is blocking the air ways. Make sure you tank has over 1000p.s.i. left in the tank, and that it has a high output pressure(800's)on the tank.
Also if you just got the X-Valve then you got the Level 10 bolt with it. You have to tune the bolt to make it work. Usually when you get the bolt it wont shoot for a while until you get the right setup. Follow the instructions that came with it until you can get it to start shooting. Also your going to have to turn up your velocity WAY up to get it to shoot.