I have a 9vot Richochet AK. Yesterday when I was playing my hopper was really wiggin out. When I shoot the hopper spins like its supposed to, but sometimes when I DIDNT shoot it would spin for no reason. I would have to keep my hopper off until I was about to shoot. Do you think its time to get a new hopper, or do you know whats going on with it?
-
WANTED: Y-Grip in good condition. X-Valve, or Retro Valve. PM me if you're selling one. -
anybody?WANTED: Y-Grip in good condition. X-Valve, or Retro Valve. PM me if you're selling one. -
Were you moving when it agitated? Sometimes (not alot) I will bump my gun and a ball will move a little bit and trip the switch.
Comment
-
Sometimes I was moving, but other times I was sitting still. On the feedneck the shell is cracked a little. I think that it might of messed up the position of the tap that the balls hit to make it spin. I'm either going to get a new shell or get a new hopper.WANTED: Y-Grip in good condition. X-Valve, or Retro Valve. PM me if you're selling one.Comment
-
I had the same problem awhile for mine. Ok, take the thing apart and check the connections between the control board and the sensor, sometimes it comes loose and activates when it is bumped or moved. It should work after that, if not send it back to ricochet, they have a pretty good service department._______________________________________
Yeah, that's right!Comment
-
pull it apart and clean the sensor pad and look for any exposed wires. IF you send Rico an email they may send you a new set of shells for free. I have the old ver 1.0 rico told them I needed shells and they sent a set to me priority mail free o' charge!Comment
-
hehe just be carefull when you are pulling it apart, one time i was pulling out the board and motor to do my routine cleaning of my equipment and not realizing i had the board in my hand but the motor was hanging on the wires, well my bad luck just had to prove it's existance that day and the motor just fell off of the wires, luckily soldering isn't too hard and i got it working in no time
Comment
-
call up or e-mail ricochet and they'll send you any replacement parts you need 100% free of charge... great company i tell ya
ps: i have one of the new Ricochet Apache's
Proud Member Of The AO Cesspool Since 08-24-2002Comment
-
Ok, I'll contact them, but theres a problem. I dont know their website or anything like that. If you know their website can you please post it?WANTED: Y-Grip in good condition. X-Valve, or Retro Valve. PM me if you're selling one.Comment
-
-
Ok thanks I just e-mailed them about it.WANTED: Y-Grip in good condition. X-Valve, or Retro Valve. PM me if you're selling one.Comment
Comment