on/off pin dilema

[hAppy]

alright this is how it goes...
i have on/off pins .75, .76, .765

but i have several valves that im not sure which pins belong to which valves for the following setups...

rt pro valve --> automag
xvalve --> rt custom
xvalve --> emag
rt pro valve --> rt pro

dayspring had answered this question for me awhile back, but his advice didnt save ALL my guns

so if you guys can tell me which pins i need, i will go buy them if i do not have them. i have read the tolerance sticky, but it doesn't answer my questions. any help will be GREATLY appreciated

[Evil1]

I know the pin length in the emag is .712" and I got a .750" in my RTPro.

[RRfireblade]

E-Mag:
On/Off pin: .712" w/ brass top and double o-ring top.
.725" w/ aluminum top and single o-ring top.


RT-Pro:
On/Off Pin: .765"


Retro Valve/X-Valve/Classic RT:
On/Off Pin: .750"

Automag Classic/Minimag:
on/Off Pin: .750"

That's for the gun the valves in,not the valve alone.Any valve w/ the right pin will work in any gun.('cept for a banjo bolt conflict.)

[Dayspring]

Re: on/off pin dilema

For the third time...

rt pro valve --> automag-- .750
xvalve --> rt custom-- .765
xvalve --> emag-- .712
rt pro valve --> rt pro-- .765

Originally posted by xXhAppyAznXx

rt pro valve --> automag
xvalve --> rt custom
xvalve --> emag
rt pro valve --> rt pro

[hAppy]

it makes so much sense now from what RRfireblade said thanks!

and thanks again dayspring and AGDFlash