if my x-mag is in electric mode the gun doesnt notice the trigger pull at all what could be wrong? in mechanical mode it does. in electric the shot count doesnt go up and the trigger test doesnt go on just stays off man i need help bad!
-
Last edited by islandboi; 02-08-2004, 10:43 PM.I won't ship first unless you have a lot of good feedback. -
Have you tryed adjusting the HES magnet?
Back it out a fair bit and slowly turn it back in while in trigger test mode till it trips it,then go another half turn or so.
Jay.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
-
not workingI won't ship first unless you have a lot of good feedback.Comment
-
Make sure the ACE is off as well.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
-
yea its off ill try to bring it into my shop if they cant fix it ill send it in to agdI won't ship first unless you have a lot of good feedback.Comment
-
Are you saying that the gun doesn't notice the electronic activation in emode but does notice it electronically while in manual mode? If that is the case, then the HES magnet needs to be adjusted closer to the HES.
Does the emag boot properly? Does it show the proper LED outputs? AGD 3.2, etc.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
I just got a new magnet/adjuster from AGD, and the magnet was mounted backwards. I had to break it off the adjuster and re-glue it on the correct side before my HES noticed the trigger pulls.
Comment
-
My magnet isn't even glued to my adjuster. It just sticks there by magnetism.
The reversed magnet magnet idea is the same one I was thinking about actually, which would be my prognosis if the gun indeed does not funtion electronically, even in manual maode.Except for the Automag in front, its usually the man behind the equipment that counts.Comment
-
has it ever worked in emode?
check the hall sensor and see if all three wires are in tact
another thing you can do when you have the hall sensor out is pull one of your magnets out of the "return magnet stack" and put it close to the sensor. if it trips like that you know something is wrong with the way your trigger/magnet is set upComment
-
it boots up properly and I have used it in electric beforeI won't ship first unless you have a lot of good feedback.Comment
Comment