Possible problem with RT

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • ~WarpedRT~
    #1

    Possible problem with RT

    I was fiddling with my gun, and noticed that if I pushed on the back of the valve, it would leak out the back. The tank is only at about 200 psi, but I'm not sure if this would happen with a full tank, but I never noticed it then. Could this leak be a problem, or is it normal? Alsom I can pull the back of the valve out the back, and it stops leaking. Maybe I dont' have the banjo in tight enough? I always keep it loose enough to get it out with my fingers.

    Thanks in advance for all the help.
    Tags: None
    • Butterfingers
      PhD in Automagology
      • Jan 2001
      • 2263
      #2
      well

      go fill up and see what happens... sometimes the RT valve needs a large burst of air to seat the o-rings
      Did you hear about the new european weapons contracts? France is going to make the wooden sticks Spain making the little white flags

        Comment

        • Tunaman
          Specialized AGD Tech

          • Dec 2000
          • 8643
          #3
          Always tighten the Banjo with a wrench. I also have found this to be a small annoyance
          Email me for low prices on ALL AGD Products and more. [email protected]
          Tunamart

            Comment

            • ~WarpedRT~
              #4
              Hmm, yes, I tightened the banjo, and that seemed to decrease the leak by a large percentage. Now I will go and get my air filled, after all it was only at about 100 psi. Well, thanks for your help guys. Get back to you about the problem later.

                Comment

                Previous template Next
                Working...